The PPI 100E level meter is submersible and is designed to measure fluid levels.
The level meter housing and membrane are made of corrosion-resistant stainless steel. The sensor and electronic circuit are integrated, which increases accuracy and stability over time. The electronics in the housing are covered with special resin. The meter's power supply is remote (via a current loop) and must come from a stable, tested circuit.
It is used in potentially explosive areas (mines, industry ...)
Features:
measuring the levels of corrosive and aggressive media
loop power 4 to 20mA
stainless steel housing
compact and robust design
air tube cable, Kevlar fibre and polyethylene coating and insulation
low margin of error
easy to install
Standards: SIST EN 60079-0:2012 SIST EN 60079-11:2012 SIST EN 60079-26:2007
Power supply:
12-24V DC (after a current loop from a stable, tested circuit)
Measuring area:
Custom (up to 300m)
Pressure overload:
max. 300%
Output signal:
current 4 to 20mA
Maximum current loop resistance (at 24V DC of power):
»Prejete podatke bomo uporabljali le za namen povpraševanja. Brez vašega soglasja prejetih podatkov ne bomo hranili, obdelovali ali posredovali tretjim osebam.«